Possible malfunction
NOTE:
- The system may not operate normally under the following conditions:
- The rear bumper near the blind spot monitoring (BSM) control module has become deformed.
- Snow, ice or mud adheres to the blind spot monitoring (BSM) control module on the rear bumper
- Under bad weather conditions such as rain, snow and fog.
- Stationary objects on a road or a road side such as small, two-wheeled vehicles, bicycles, pedestrians, animals, and shopping carts.
- Vehicle shapes which do not reflect radar waves well such as empty trailers with a low vehicle height and sports cars.
- Turn off the system while pulling a trailer or while an accessory such as a bicycle carrier is installed to the rear of the vehicle. Otherwise, the radio waves emitted by the radar will be blocked causing the system to not operate normally.
- The blind spot monitoring control module (RH) cannot receive the TNS switch signal.
- TNS switch (light switch) malfunction (stuck)
- Instrument cluster malfunction
- Blind spot monitoring (BSM) control module (LH) malfunction