Diagnostic Procedure
DTC U0452:92 (INSTRUMENT CLUSTER) DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | ACTION | |
|---|---|---|---|
| 1 | PERFORM SAS CONTROL MODULE DTC INSPECTION
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .) |
| No | Go to the next step. | ||
| 2 | PERFORM DTC INSPECTION AND VERIFY THAT MALFUNCTIONING PART IS SAS CONTROL MODULE
|
Yes | Replace the SAS control module, then go to the next step. (See SAS CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to Step 4. | ||
| 3 | VERIFY TROUBLESHOOTING COMPLETED
|
Yes | Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 4 | VERIFY THAT NO OTHER DTCs ARE PRESENT
|
Yes | Go to the applicable DTC inspection. (See DTC TABLE [INSTRUMENT CLUSTER] .) |
| No | DTC troubleshooting completed. | ||