LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> 3 Sport, 4D Sedan, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transaxle System (Service Information)) >> Automatic Transaxle Removal/Installation >> No. 4 engine mount bracket removal note >> Transaxle mounting bolt removal note

Transaxle mounting bolt removal note

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • Remove the transaxle carefully, holding it steady. If the transaxle falls it could be damaged or cause injury.
  1. Adjust the SST and lean the engine toward the transaxle.
    Fig 1: Adjusting SST And Lean Engine Toward Transaxle
    G09786134Courtesy of MAZDA MOTORS CORP.
  2. Support the transaxle on a jack.
    Fig 2: Supporting Transaxle On Jack
    G09075467Courtesy of MAZDA MOTORS CORP.
  3. Remove the transaxle mounting bolts (lower side).
  4. Remove the transaxle.
scientia non olet · About LEMON Manuals