Indicator Removal/Installation (With Electric Parking Brake): Notes

1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
2. Remove the following parts:
   1. Upper panel (See UPPER PANEL REMOVAL .) (See UPPER PANEL INSTALLATION .)
   2. Selector lever knob (See Selector Lever Removal/Installation .)
   3. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION .)
3. Turn over the removed shift panel and remove the boots from the securing parts shown in the figure.
   Fig 1: Shift Panel And Boots Securing Parts

   Courtesy of MAZDA MOTORS CORP.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.

Fig 2: Removing Indicator Connector, Screw, Indicator Panel, Indicator, Drive Selection Switch And Connector

Courtesy of MAZDA MOTORS CORP.

COMPONENT DESCRIPTION

1	Indicator connector
2	Drive selection switch connector
3	Screw
4	Drive selection switch
5	Indicator panel
6	Indicator (See Indicator Removal/Installation (With Electric Parking Brake) .)