LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2016 >> 6 Touring, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> C-Pillar Trim Removal/Installation

C-Pillar Trim Removal/Installation

  1. Remove the following parts:
    1. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
    3. Rear seat side back (See REAR SEAT SIDE BACK REMOVAL/INSTALLATION .)
    4. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
  2. Set the rear seat belt aside from the slit area shown in the figure.
    Fig 1: Identifying Rear Seat Belt, Slit Area And C-Pillar Trim
    G11012000Courtesy of MAZDA MOTORS CORP.
  3. Pull the C-pillar trim in the direction of the arrow in the order of (1), (2) while detaching clip A, clip B and guides.
    Fig 2: Pulling C-Pillar Trim
    G11012001Courtesy of MAZDA MOTORS CORP.
  4. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals