LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2016 >> 6 Touring, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> B-Pillar Upper Trim Removal/Installation

B-Pillar Upper Trim Removal/Installation

  1. Remove the following parts:
    1. Front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    3. B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .)
    4. Adjuster anchor cover (See FRONT SEAT BELT REMOVAL/INSTALLATION .)
    5. Upper anchor installation bolts on the front seat belt (See FRONT SEAT BELT REMOVAL/INSTALLATION .)
  2. Partially peel back the seaming welt.
  3. Grasp the shaded area shown in the figure, and pull the B-pillar upper trim in the direction of the arrow (1) while detaching clips, pin A, pin B.
    Fig 1: Pulling B-Pillar Upper Trim
    G11011999Courtesy of MAZDA MOTORS CORP.
  4. Remove the B-pillar upper trim in the direction of the arrow (2) shown in the figure while detaching the guide.
    CAUTION:
    • If clips, pin A and pin B are removed forcefully, guide may be damaged. Carefully remove clips, pin A and pin B so as not to damage guide.
  5. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals