Diagnostic Procedure

Step	Inspection		Action
1	INSPECT ACTIVE DRIVING DISPLAY Inspect the active driving display. (See ACTIVE DRIVING DISPLAY INSPECTION .) Is the active driving display normal?	Yes	Go to the next step.
1		No	Replace the active driving display, then go to the next step. (See ACTIVE DRIVING DISPLAY REMOVAL/INSTALLATION .)
2	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the DTC for the instrument cluster using the M-MDS. (See CLEARING DTC [INSTRUMENT CLUSTER] .) Perform the DTC inspection for the instrument cluster using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Is the same DTC displayed?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .) Go to the next step.
2		No	Go to the next step.
3	VERIFY OTHER DTCs Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .)
3	VERIFY OTHER DTCs Are any other DTCs displayed?	No	DTC troubleshooting completed.