LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2016 >> 6 Touring, Standard Trans >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> On-Board Diagnostics [Dynamic Stability Control] >> DTC U2300-52; U2300-54; U2300-55; U2300-56; U2300-64: Configuration Data Not Recorded >> Diagnostic procedure

Diagnostic procedure

STEP INSPECTION ACTION
1 RECORD CONFIGURATION DATA 
  • Switch the ignition OFF.
  • Switch the ignition ON (engine off), and maintain this condition for approx. 10 s or more.
  • Switch the ignition OFF, and maintain this condition for approx. 3 s or more.
  • Switch the ignition ON (engine off), and maintain this condition for approx. 3 s or more.
 Go to the next step.
2 VERIFY DSC HU/CM DTC 
 Yes Repeat the inspection from Step1.
If the malfunction recurs, go to the next step.
No Go to Step 6.
3 VERIFY IF PARTS FROM ANOTHER VEHICLE INSTALLED TO INSTRUMENT CLUSTER, PCM OR DSC HU/CM 
  • Verify if an instrument cluster, PCM or DSC HU/CM from another vehicle is installed.
  • Has an instrument cluster, PCM, DSC HU/CM or other vehicle part been installed to vehicle?
 Yes Install the correct instrument cluster, PCM or DSC HU/CM, then go to Step1.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
(See PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.5] .)
(See DSC HU/CM REMOVAL/INSTALLATION .)
No Go to the next step.
4 VERIFY INSTRUMENT CLUSTER AND PCM DTC 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE [INSTRUMENT CLUSTER] .)
(See DTC TABLE [SKYACTIV-G 2.5] .)
DTC troubleshooting completed, then go to the next step
No Go to the next step.
5 VERIFY DTC TROUBLESHOOTING COMPLETED 
 Yes Repeat the inspection from Step1.
No Go to the next step.
6 VERIFY NO DTC IS PRESENT 
  • Are any DTCs present?
 Yes Go to the applicable DTC inspection.
(See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)] .)
No DTC troubleshooting completed.
scientia non olet · About LEMON Manuals