DTC C0044-14; C0044-1C; C0044-65; C0044-66; C0044-67: Brake Fluid Pressure Sensor: Notes

• With the DSC HU/CM terminal voltage within the normal range, the brake fluid pressure sensor power supply voltage is 4.7 V or less  , or 5.3 V or higher  for a continuous 1.2 s  , or the brake fluid pressure sensor output value is less than the specified value or exceeds than the specified value for a continuous 1.2 s  .

0-point output 

• The brake fluid pressure sensor output value is less than the specified value or it exceeds than specified value for a continuous 5 s  with the brake switch in the off condition.

Output increase 

• The following condition is detected 9 times  continuously (One detection period is when ignition is switched from ON to off).
  • While the vehicle is traveling at a speed of 7 km/h {4 mph} or more  , the deceleration rate calculated from the brake fluid pressure sensor signal value is detected 5 times or more  at 1/4 or less  than the normal value for a continuous 1 s  .

Sticking 

• While the vehicle is traveling at a speed of 7 km/h {4 mph} or more  , no fluctuation in the output value at 0.048 MPa {0.49 kgf/cm ²  , 7.0 psi} or higher  is detected with the brake fluid pressure sensor output value exceeding specified value.

Sticking during braking 

• While the vehicle is traveling at a speed of 40 km/h {25 mph} or more,  the amount of fluctuation in the brake fluid pressure sensor value is detected 5 times  to be 0.048 MPa {0.49 kgf/cm ²  , 7.0 psi} or less  until the vehicle speed reaches 0 km/h {0 mph}  and with the brake switch on.

• While the vehicle is traveling at a speed of 10 km/h {6.2 mph} or more,  a brake fluid pressure sensor signal value of 1000 MPa/s or more  is detected 7 times or more  during a 5 s  period.

• Brake fluid pressure sensor malfunction
• Short or open circuit in brake fluid pressure sensor circuit