LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2016 >> 6 Touring, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Rear Seat Warmer Unit Inspection >> RH-Side >> Seat back side

Seat back side

  1. Switch the ignition to off.
  2. Disconnect the negative battery cable and wait 1 min. or more  . (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  3. Remove the rear seat. (See REAR SEAT BACK REMOVAL/INSTALLATION .)
  4. Inspect for continuity between the seat warmer unit connector (short code) terminal A and B.
    Fig 1: Inspecting Continuity Between Seat Warmer Unit Connector (Short Code) Terminals
    G10987730Courtesy of MAZDA MOTORS CORP.
    Fig 2: Rear Seat Back Pad Terminal Continuity Chart
    G10987731Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals