LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2016 >> 6 Touring, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Front Seat Warmer Control Unit Inspection >> Inspection Procedure (No. 2 Front Seat Warmer Always Operations) >> Diagnostic procedure

Diagnostic procedure

STEP INSPECTION ACTION
1* DETERMINE IF THE MALFUNCTION CAUSE IS THE FRONT SEAT WARMER SWITCH 
  • Switch the ignition off (LOCK).
    • Disconnect the indicator unit connector.
  • Switch the ignition ON (engine off or on).
  • Is the front seat warmer system operating?
 Yes Go to the next step.
No Replace the indicator unit.
(See INDICATOR UNIT REMOVAL/INSTALLATION .)
2 DETERMINE IF THE MALFUNCTION CAUSE IS THE FRONT SEAT WARMER COTROL UNIT 
  • Disconnect the front seat warmer control unit connector.
  • Measure the voltage between front seat warmer control unit terminal I and body ground.
  • Is the voltage 1.0 or more  ?
 Yes Repair or replace for a short to ground in the wiring harness.
No Replace the front seat warmer control unit.
(See FRONT SEAT WARMER CONTROL UNIT REMOVAL/INSTALLATION .)
scientia non olet · About LEMON Manuals