DTC P0773-00: On/Off Solenoid Circuit Malfunction: Notes

WARNING: This page is about a different variant/trim than selected.

DTC P0773:00	On/off solenoid circuit malfunction
DETECTION CONDITION	Under the following condition, the TCM detects the on/off solenoid circuit malfunction: Battery voltage is 10.5 V or more.
FAIL-SAFE FUNCTION	Set to emergency mode. Inhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS.
POSSIBLE CAUSE	Short or open circuit in on/off solenoid circuit On/off solenoid malfunction
SYSTEM WIRING DIAGRAM	Not applicable