LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2014 >> 3 SV, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transaxle (Service Information)) >> Oil Cooler Removal/Installation >> Water Hose >> Water Hose No. 1 and No. 2 (oil cooler side) Installation Note

Water Hose No. 1 and No. 2 (oil cooler side) Installation Note

WARNING: This page is about a different variant/trim than selected.
  1. Install the water hose to the oil cooler as shown in the figure with the hose clamp expanded.
    NOTE:
    • A new water hose and hose clamp are attached.
    Fig 1: Identifying Water Hose And Oil Cooler
    G09783233Courtesy of MAZDA MOTORS CORP.
  2. Install the hose clamp so that center A of the hose clamp tab is within the range shown in the figure.
    • Verify that the installation angle of the hose clamp is within the range shown in the figure.
  3. Verify that the hose clamp does not interfere with any other components.
    Fig 2: Identifying Water Hose Clamp Position
    G09783234Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals