LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2014 >> 3 SV, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transaxle (Service Information)) >> Drive Plate Removal/Installation >> Drive Plate Installation Bolts Removal Note

Drive Plate Installation Bolts Removal Note

WARNING: This page is about a different variant/trim than selected.
  1. Set the SST  against the drive plate.
  2. Loosen the drive plate installation bolts uniformly in two or three steps in the order shown in the figure, then remove the bolts and the drive plate.
    Fig 1: Removing Drive Plate Using Tool
    G09783216Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals