LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2014 >> 3 SV, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (On-Board Diagnostic - Automatic Transaxle) >> DTC P1738: 00 Automatic Transaxle Internal Malfunction >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
DTC P1738:00 (FW6A-EL) - DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 INSPECT ATF LEVEL 
Yes Go to Step 4.
No Adjust the ATF level to the specification, then go to the next step.
(See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT .)
2 PERFORM ON-BOARD DIAGNOSTIC TEST TO SPECIFY MALFUNCTIONING PART 
NOTE:
  • If only DTCs in which the malfunctioning part is not confirmed are displayed as in the following DTCs, all of the diagnosis may not have been completed. In such cases, the malfunction cause can be determined by performing the on-board diagnostic test.

Yes DTC P1738:00 is displayed:

DTC other than P1738:00 is displayed:
No Go to the next step.
3 DRIVE VEHICLE AND VERIFY DTCs 
Yes DTC P1738:00 is displayed:

DTC other than P1738:00 is displayed:
No No DTCs are displayed:
  • DTC troubleshooting completed.
4 PERFORM ON-BOARD DIAGNOSTIC TEST 
Yes DTC P1738:00 is displayed:

DTC other than P1738:00 is displayed:
No Go to the next step.
5 DRIVE VEHICLE AND VERIFY DTCs 
Yes DTC P1738:00 is displayed:

DTC other than P1738:00 is displayed:
No Replace the control valve body.
(See CONTROL VALVE BODY REMOVAL/INSTALLATION .)