DTC P0780: 00 Gear Shifting Malfunction: Notes

WARNING: This page is about a different variant/trim than selected.

DTC P0780:00 DETECTION CONDITIONS AND POSSIBLE CAUSES (FW6A-EL)

DTC P0780:00	Gear shifting malfunction
DETECTION CONDITION	Under the following condition, the gear shifting inhibited: Engine is running. Diagnostic support note The check engine light illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM. The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM. PENDING CODE is available. FREEZE FRAME DATA is available. DTC is stored in the TCM memory.
FAIL-SAFE FUNCTION	Inhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS.
POSSIBLE CAUSE	ATF is less than specified value On/off solenoid malfunction Pressure control solenoid malfunction Shift solenoid malfunction Oil pressure switch circuit malfunction Oil pressure switch malfunction Clutch slippage ATF leakage from clutch circuit Control valve body malfunction
SYSTEM WIRING DIAGRAM	Not applicable