DTC P0773: 00 On/Off Solenoid Circuit Malfunction: Notes
WARNING: This page is about a different variant/trim than selected.
DTC P0773:00 DETECTION CONDITIONS AND POSSIBLE CAUSES (FW6A-EL)
| DTC P0773:00 |
On/off solenoid circuit malfunction |
| DETECTION CONDITION |
- Under the following condition, the TCM detects the on/off solenoid circuit malfunction:
- Battery voltage is 10.5 V or more.
Diagnostic support note
- The check engine light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
- Set to emergency mode.
- Inhibits learning control.
- Inhibits manual mode.
- Inhibits neutral idle control.
- Inhibits AAS.
|
| POSSIBLE CAUSE |
- Short or open circuit in on/off solenoid circuit
- On/off solenoid malfunction
|
| SYSTEM WIRING DIAGRAM |
Not applicable |