DTC P0758: 00 Shift Solenoid No. 2 Circuit Malfunction: Notes
WARNING: This page is about a different variant/trim than selected.
DTC P0758:00 DETECTION CONDITIONS AND POSSIBLE CAUSES (FW6A-EL)
| DTC P0758:00 |
Shift solenoid No. 2 circuit malfunction |
| DETECTION CONDITION |
- Under the following condition, the TCM detects the shift solenoid No. 2 circuit malfunction:
- Battery voltage is 10.5 V or more.
Diagnostic support note
- The check engine light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- PENDING CODE is available.
- FREEZE FRAME DATA is available.
- DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
- Set to emergency mode.
- Inhibits learning control.
- Inhibits manual mode.
- Inhibits neutral idle control.
- Inhibits AAS.
|
| POSSIBLE CAUSE |
- Short or open circuit in shift solenoid No. 2 circuit
- Shift solenoid No. 2 malfunction
|
| SYSTEM WIRING DIAGRAM |
Not applicable |