DTC P073D: 00 Neutral Incorrect Ratio: Notes

WARNING: This page is about a different variant/trim than selected.

DTC P073D:00 DETECTION CONDITIONS AND POSSIBLE CAUSES (FW6A-EL)

DTC P073D:00	Neutral incorrect ratio
DETECTION CONDITION	In P or N position, the following phenomenon occurs: Speed ratio is 0.5 or less for 2 s while vehicle is stopped in P or N position. Diagnostic support note The check engine light does not illuminate. The automatic transaxle warning light does not illuminate. PENDING CODE is available. FREEZE FRAME DATA is not available. DTC is stored in the TCM memory.
FAIL-SAFE FUNCTION	Not applicable
POSSIBLE CAUSE	Clutch stuck Turbine/input shaft speed sensor malfunction
SYSTEM WIRING DIAGRAM	Not applicable