Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.

DTC P0734:00 (FW6A-EL) - DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY DTC OUTPUT STATUS Are any the following DTCs displayed? P0738:00, P0746:00, P0751:00, P0752:00, P0756:00, P0757:00, P0761:00, P0762:00, P0766:00, P0767:00, P0771:00, P0772:00, P0842:00, P0843:00, P0847:00, P0848:00, P0872:00, P0873:00, P0877:00, P0878:00, P1784:00	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE .)
1		No	Go to the next step.
2	INSPECT ATF LEVEL Inspect the ATF level. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION .) Is there any malfunction?	Yes	Adjust the ATF level to the specification, then go to the next Step. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT .)
2		No	Go to the next step.
3	PERFORM ON-BOARD DIAGNOSTIC TEST TO SPECIFY MALFUNCTIONING PART NOTE: If only DTCs in which the malfunctioning part is not confirmed are displayed as in the following DTCs, all of the diagnosis may not have been completed. In such cases, the malfunction cause can be determined by performing the on-board diagnostic test. Perform the on-board diagnostic test. (See ON-BOARD DIAGNOSTIC TEST MODE .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE .)
3		No	ATF amount in Step 2 is correct: Replace the automatic transaxle. (See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION .) ATF amount adjusted in Step 2: Drive the vehicle to check it, and if there is no problem then the DTC troubleshooting is complete.