Clearing DTCs Procedure
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS(IDS) to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the IDS.
- Select "Self Test".
- Select "Modules".
- Select "TCM".
- Verify the DTC according to the directions on the screen.
- Press the clear button on the DTC screen to clear the DTC.
- Switch the ignition OFF.
- Switch the ignition ON and wait 5 s or more.
- Perform DTC inspection. (See READING DTCS PROCEDURE .)
- Verify that no DTCs are displayed.