DTC P1783:00: Notes
WARNING: This page is about a different variant/trim than selected.
| DTC P1783:00 |
ATF high oil temperature malfunction |
| DETECTION CONDITION |
- Under the following conditions, ATF temperature is 149.5 °C {301.1 °F} or more
- TFT sensor related DTC is not recorded
- TFT sensor voltage is 0.12 V or more
Diagnostic support note
- The check engine light does not illuminate.
- The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- PENDING CODE is not available.
- FREEZE FRAME DATA is not available.
- The DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
- Inhibits feedback control
|
| POSSIBLE CAUSE |
- High engine load drive (Driving a steep gradient at a low speed.)
- Deteriorated ATF
- Insufficient or excess level of ATF
- TCM malfunction
|
| SYSTEM WIRING DIAGRAM |
- |