LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Sport, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle (Service, Removal & Installation FS5A-El)) >> Solenoid Valve Inspection >> Secondary Control Valve Body >> On-vehicle inspection

On-vehicle inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the coupler component connector.
    1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
    2. Disconnect the negative battery cable.
    3. Remove the battery. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
    4. Remove the battery tray. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
    5. Disconnect the coupler component connector.
      Fig 1: Identifying Coupler Component
      G08152112
  2. Measure the solenoid valve resistance.
    Fig 2: Identifying Coupler Component Connector Terminals
    G08152113
    • If there is any malfunction, inspect the coupler component continuity.
    • If there is any malfunction in the coupler component, inspect the solenoid valves individually. (See PART INSPECTION .)
    SOLENOID VALVE RESISTANCE

    Solenoid Valve Terminal Resistance (ohm)
    Pressure control solenoid B A-GND 1.0-4.2
    Shift solenoid F B-GND 8.4-21.8
scientia non olet · About LEMON Manuals