Part inspection

WARNING: This page is about a different variant/trim than selected.

Measure the solenoid valve resistance.
- If there is any malfunction, replace the solenoid valve.
Fig 1: Identifying Pressure Control Solenoid A Connector Terminals

Pressure control solenoid A resistance
- 2.4-7.3 ohms
Fig 2: Identifying Shift Solenoids A, B, And C Connector Terminals

Resistance of shift solenoids A, B, and C
- 1.0-4.2 ohms
Fig 3: Identifying Shift Solenoids D And E Connector Terminals

Resistance of shift solenoids D and E
- 10.9-26.2 ohms