LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Sport, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle (Service, Removal & Installation FS5A-El)) >> Oil Pressure Switch Inspection >> Part Inspection

Part Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Apply air pressure of 400-440 kPa {4.08-4.48 kgf/cm 2  , 58.1-63.8 psi}  to the oil pressure switch as shown in the figure.
    Fig 1: Checking Oil Pressure Switch Continuity
    G08152085
  2. Measure continuity between oil pressure switch terminal A and the thread area.
    Fig 2: Identifying Oil Pressure Switch Connector Terminals
    G08152086
    • If there is any malfunction, replace the oil pressure switch.
    OIL PRESSURE SWITCH CONTINUITY

    Measurement Conditions Continuity
    Air pressure applied Yes
    Air pressure not applied No
scientia non olet · About LEMON Manuals