LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Sport, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle (Service, Removal & Installation FS5A-El)) >> Oil Pressure Switch Inspection >> On-Vehicle Inspection Preparation

On-Vehicle Inspection Preparation

WARNING: This page is about a different variant/trim than selected.
  1. When performing the on-vehicle inspection, set the oil cooler out of the way.
    1. Disconnect the oil cooler from the transaxle. (See OIL COOLER REMOVAL/INSTALLATION .)
      NOTE:
      • Do not disconnect the oil hose and water hose from the oil cooler and transaxle because the engine is started when performing the on-vehicle inspection.
    2. Suspend the oil cooler using rope to secure the disconnected oil cooler.
      Fig 1: Suspending Oil Cooler Using Rope
      G08152082
      CAUTION:
      • To prevent damage to the parts, do not pull the oil hose and water hose excessively.
      • To prevent damage to the parts, do not twist the oil hose and water hose.
      • To prevent part damage, do not allow parts to interfere with the cooling fan.
scientia non olet · About LEMON Manuals