LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Sport, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels And Bumpers >> Rear Bumper Removal/Installation

Rear Bumper Removal/Installation

  1. Disconnect the negative battery cable.
  2. Remove the rear combination light. (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION .)
  3. Remove the rear splash shield. (See SPLASH SHIELD REMOVAL/INSTALLATION .)
  4. Remove the screw A.
    Fig 1: Identifying Rear Bumper And Screw A
    G08152739
  5. Remove the screw B.
    Fig 2: Identifying Rear Bumper And Screws B
    G08152740
  6. Remove the fastener C.
    Fig 3: Identifying Rear Bumper And Fasteners C
    G08152741
  7. Affix the protective tape to the position shown in the figure.
    Fig 4: Identifying Position Of Protective Tape
    G08152742
  8. Pull the rear bumper in the direction of arrow (1), (2) shown in the figure to disengage the rear bumper from the rear bumper slider.
  9. Pull the rear bumper in the direction of arrow (3).
    Fig 5: Pulling Rear Bumper
    G08152743
    CAUTION:
    • When disengaging the rear bumper from the rear bumper slider, the rear bumper could fall and be damaged. Support the rear bumper so that it does not fall.
  10. Remove the rear bumper.
  11. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals