LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Sport, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Body Panels And Bumpers >> Front Bumper Removal/Installation >> Notes

Front Bumper Removal/Installation: Notes

  1. Disconnect the negative battery cable.
  2. Remove the fastener A.
    Fig 1: Identifying Front Bumper And Fastener A
    G08152724
  3. Remove the screw B.
    Fig 2: Identifying Front Bumper And Screw B
    G08152725
  4. Remove the screw C.
    Fig 3: Identifying Front Bumper And Screws C
    G08152726
  5. Remove the bolt D.
    Fig 4: Identifying Front Bumper, Fastener F And Bolts D
    G08152727
  6. Remove the fastener F.
  7. Pull the front bumper in the direction of the arrow in the order of (1), (2) and (3). (See
    Fig 5: Front Bumper
    G08152728
    CAUTION:
    • The front bumper and front bumper slider are engaged firmly. If they are disengaged forcibly the bumper could fall and be damaged. Perform the servicing carefully when disengaging the front bumper from the front bumper slider.
    • When disengaging the front bumper from the front bumper slider, the front bumper could fall and be damaged. Support the front bumper so that it does not fall.
  8. Disconnect the front fog light connector. (Vehicles with front fog lights)
  9. Remove the front bumper.
  10. Install in the reverse order of removal.
  11. Adjust the front fog light aiming. (Vehicles with front fog lights) (See FRONT FOG LIGHT AIMING .)
scientia non olet · About LEMON Manuals