DTC P0744:00: Notes

DTC P0744:00	TCC slip control malfunction
DETECTION CONDITION	Under the following conditions, input shaft and intermediate shaft rotation ratio is 1.09 or more, or 0.91 or less. 3GR TCC slip control: On Under the following conditions, input shaft and intermediate shaft rotation ratio is 0.817 or more, or 0.636 or less. 4GR or 5GR TCC slip control: On Diagnostic support note The check engine light does not illuminate. The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the TCM. PENDING CODE is not available. FREEZE FRAME DATA is not available. The DTC is stored in the TCM memory.
FAIL-SAFE FUNCTION	Inhibits slip control Inhibits feedback control
POSSIBLE CAUSE	Deteriorated ATF ATF level low Solenoid valve malfunction Pressure control solenoid A Shift solenoid B Shift solenoid C Shift solenoid D Shift solenoid E Line pressure low Oil pump malfunction Forward clutch slipping 2-4 brake band slipping 3-4 clutch slipping Primary control valve body malfunction TCM malfunction
SYSTEM WIRING DIAGRAM	-