| DETECTION CONDITION |
- Under the following conditions, intermediate shaft and output shaft rotation ratio is 1.11 or less
- Gear position is 3GR or 4GR
- Accelerator pedal position is 3.87% or more
- Under the following conditions, intermediate shaft and output shaft rotation ratio is 1.11 or more
- Gear position is 5GR
- Accelerator pedal position is 3.87% or more
Diagnostic support note
- The check engine light does not illuminate.
- The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle.
- PENDING CODE is not available.
- FREEZE FRAME DATA is not available.
- The DTC is stored in the TCM memory.
|
| FAIL-SAFE FUNCTION |
- Inhibits 1GR, 2GR, 4GR and 5GR
- Maximizes line pressure
- Inhibits feedback control
|
| POSSIBLE CAUSE |
- Deteriorated ATF
- ATF level low
- Solenoid valve malfunction
- Pressure control solenoid B
- Shift solenoid F
- Line pressure malfunction
- Stall speed malfunction
- Direct clutch slipping
- Reduction brake slipping
- Secondary control valve body malfunction
- TCM malfunction
|
| SYSTEM WIRING DIAGRAM |
- |