Using M-MDS
- Connect the M-MDS (IDS) to DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the IDS.
- Select "Body".
- Select "TPMS Functions".
- Select "Wheel Unit ID Registration".
- Select an item from the screen menu.
- Wheel unit ID registration: WU ID Registration
- Monitoring wheel unit ID: Monitor WU ID Registration
- Leave the vehicle with the ignition to off for 15 min or more
.
- Switch the ignition to ON (engine ON).
- Verify that the TPMS warning light turns on and off in 0.5 s
cycles repeatedly.
- Drive the vehicle at a speed of 25 km/h {15.5 mph} or more
for 10 min
to implement the wheel unit ID registration.
NOTE:
- If the ID registration is not completed even after driving the vehicle for 10 min
or more at a speed of 25 km/h {15.5 mph} or more
, the TPMS warning light flashes.
- Verify that the TPMS warning light turns off.
NOTE:
- If the wheel unit ID registration cannot be performed after driving 10 min
or more, refer to the symptom troubleshooting procedure.