Diagnostic Procedure

STEP	INSPECTION		ACTION
1	VERIFY PROGRAMMED ID OF WHEEL UNIT Switch the ignition to off. Connect the M-MDS to the DLC-2. Select the following PIDs using the M-MDS: (See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS .) WU1_ID WU2_ID WU3_ID WU4_ID Switch the ignition to ON. Is the same code in the output ID?	Yes	Configure the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER CONFIGURATION .)
1		No	Go to the next step.
2	VERIFY TROUBLESHOOTING COMPLETED Clear the DTC from the instrument cluster memory using the M-MDS. (See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS .) Drive the vehicle at speed of 25 km/h {15.5 mph} or more for 10 min or more . Retrieve the TPMS DTC using the M-MDS. (See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS .) Is the same DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCs ARE PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See TIRE PRESSURE MONITORING SYSTEM (TPMS) ON-BOARD DIAGNOSIS .)
3		No	DTC troubleshooting completed.