Diagnostic Procedure

STEP	INSPECTION		ACTION
1	INSPECT FOR BCM MALFUNCTION Using the M-MDS, perform the DTC inspection for the BCM. (See DTC INSPECTION [BCM] .) Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE [BCM] .) DTC troubleshooting completed, then go to the next step.
1		No	Go to the next step.
2	VERIFY THAT SAME DTC IS NOT PRESENT Clear the DTC from the memory. (See ELECTRO HYDRAULIC POWER ASSIST STEERING (EHPAS) ON-BOARD DIAGNOSIS .) Is the same DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the electric power steering oil pump component. (See ELECTRIC POWER STEERING OIL PUMP COMPONENT REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCs ARE PRESENT Are any other DTCs output? (See ELECTRO HYDRAULIC POWER ASSIST STEERING (EHPAS) ON-BOARD DIAGNOSIS .)	Yes	Go to the applicable DTC inspection. (See ELECTRO HYDRAULIC POWER ASSIST STEERING (EHPAS) ON-BOARD DIAGNOSIS .)
3		No	DTC troubleshooting completed.