Manual Transaxle Clutch Fluid Inspection
WARNING: This page is about a different variant/trim than selected.
NOTE:
- A common reserve tank is used for the clutch system and brake system.
- Verify that the clutch fluid is between the MIN mark and the MAX mark.
- If clutch fluid level is lower than MIN mark, perform the following procedure:
- Verify that there is no clutch fluid leakage. (See CLUTCH FLUID LEAKAGE INSPECTION .)
- Add clutch fluid to the level between MIN mark and MAX mark.
Clutch fluid
- SAE J1703 or FMVSS116 DOT-3