Clutch Disc and Cover Installation Note

WARNING: This page is about a different variant/trim than selected.

Hold the clutch disc position using the SST .

Fig 1: Holding Clutch Disc Position Using SST
Hold the clutch unit using the SST .

Fig 2: Holding Clutch Unit Using SST
Tighten the bolts in Min. 2 stages.
1. Temporarily tighten the bolts in the order shown in the figure.
2. Tighten the bolts completely in the order shown in the figure and install the clutch disc and cover.
Tightening torque
- 25-33 N.m {2.6-3.3 kgf.m, 19-24 ft.lbf}