LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Disc Brake System & Drum Brake System) >> Adjustments >> Parking Brake Cable >> Vehicles With Low Series Floor Console

Vehicles With Low Series Floor Console

WARNING: This page is about a different car, the 2004 Mazda Tribute, 2003 Mazda Tribute, and 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Numbers in parenthesis refer to numbers in illustration.
  1. If equipped, remove the manual transaxle shift knob by turning it counterclockwise (1). Remove the floor console front finish panel (2). See Fig 1 .
  2. Apply the parking brake (1). Remove the floor console rear finish panel (2). See Fig 2 .
  3. Remove the adjustment nut clip.
  4. Turn the parking brake control adjustment nut so that the parking brake control stroke is three to five notches when pulled. See Fig 3 .
  5. Confirm the parking brake is applied.
  6. Install the adjustment nut clip.
  7. Install the floor console rear finish panel.
  8. Install the floor console front finish panel. If equipped, install the manual transaxle shifter knob.
Fig 1: Removing Front Floor Console Finish Panel
G00303139Courtesy of MAZDA MOTORS CORP.
Fig 2: Removing Rear Floor Console Finish Panel
G00303140Courtesy of MAZDA MOTORS CORP.
Fig 3: Locating Brake Control Adjustment Nut
G00303142Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals