LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Mechanical (Service Information L3)) >> Front Oil Seal Replacement >> Crankshaft Pulley Lock Bolt Removal Note

Crankshaft Pulley Lock Bolt Removal Note

WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cylinder block lower blind plug.
  2. Install the SST  .
    Fig 1: Installing SST
    G01929579Courtesy of MAZDA MOTORS CORP.
  3. Rotate the crankshaft clockwise until the crankshaft is in the No.1 cylinder TDC position (until the balance weight is contacting to the SST  ).
  4. Hold the crankshaft pulley using the SSTs 
    Fig 2: Holding Crankshaft Pulley
    G01929580Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals