LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Engine Controls [Removal & Installation]) >> Variable Valve Timing System >> Oil Control Valve >> Removal & Installation (Mazda6 2.3L)

Removal & Installation (Mazda6 2.3L)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Mazda Tribute, 2003 Mazda Protege5, 2003 Mazda Protege, 2003 Mazda MX-5 Miata, and 2003 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The high-tension leads must be reinstalled to their original positions. Incorrect installation can damage the leads and cause power loss, and negatively affect the electronic components.
  1. Disconnect negative battery cable.
  2. Remove the plug hole plate. Lift off and remove the plug hole plate from the installation areas (rubber and clips) as shown in the illustration. See Figure.
  3. Remove the high-tension lead.
  4. Disconnect Oil Control Valve (OCV) harness connector.
  5. Remove the ventilation hose.
  6. Remove the cylinder head cover.
  7. Remove bolt and OCV. See Fig 1.
Fig 1: Removing & Installing Oil Control Valve - Mazda6 (2.3L)
G00264417Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals