Top Fabric Repair: Holes

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

Place the repair sheet (NC10 R1 211) over the damaged section. Cut both the top fabric and the repair sheet using a razor and a straightedge.
Cut another piece of repair sheet larger than the first for use as a back repair sheet.

Fig 1: Placing Repair Sheet Over Damaged Section
Courtesy of MAZDA MOTORS CORP.
Trim the top fabric and the repair sheets using scissors.

Fig 2: Identifying Repair Sheets
Courtesy of MAZDA MOTORS CORP.
Degrease the repair sheets using ethyl alcohol.
Apply a generous amount of adhesive agent (K180 W0 313) or equivalent to the section being repaired, the repair sheet, and the back repair sheet. Let stand for a few minutes.

Fig 3: Degreasing Repair Sheets Using Ethyl Alcohol
Courtesy of MAZDA MOTORS CORP.
Insert the repair sheet squarely into the section of the top fabric being repaired. Then install the back repair sheet from the underside of the top.

Fig 4: Inserting Repair Sheet Squarely Into Section Of Top Fabric Being Repaired
Courtesy of MAZDA MOTORS CORP.
Press the repair sheets firmly together.

Fig 5: Pressing Repair Sheets Together
Courtesy of MAZDA MOTORS CORP.
Let the top fabric stand until the adhesive agent is fully dry.