LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 528 (Air Bag System) >> Air Bag Module Deployment Procedure >> Deployment Procedures for Inside of Vehicle >> Pre-tensioner seat belt

Pre-tensioner seat belt

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the quarter trim.
  2. Remove the pre-tensioner seat belt and connect the SST  (Adapter Harness) to it as shown in Fig 1.
    Fig 1: Connecting Adapter Harness To Pre-Tensioner Seat Belt
    G03638637Courtesy of MAZDA MOTORS CORP.
  3. Install the pre-tensioner seat belt.
  4. Connect the SST  (Deployment Tool) to the SST  (Adapter Harness).
    Fig 2: Connecting Deployment Tool To Adapter Harness
    G03638638Courtesy of MAZDA MOTORS CORP.
  5. Connect the red clip of the SST  (Deployment Tool) to the positive battery terminal and the black clip to the negative battery terminal.
  6. Verify that the red light on the SST  (Deployment Tool) is illuminated.
  7. Make sure all persons are standing at least 6 m {20 ft}  away from the vehicle.
  8. Press the activation switch on the SST  (Deployment Tool) to deploy the pre-tensioner seat belt.
scientia non olet · About LEMON Manuals