O/D Off Switch Removal/Installation
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the rear console.
- Disconnect the connector and remove the O/D OFF switch terminals. (See SELECTOR LEVER DISASSEMBLY/ASSEMBLY .)
- Remove the selector lever knob component.
- Install a selector lever knob component.
Tightening torque
- 2.0-2.9 N.m {20-30 kgf.cm, 18-26 in.lbf}
- Install the O/D OFF switch terminals and connect the connector. (See SELECTOR LEVER DISASSEMBLY/ASSEMBLY .)
- Install the rear console.
- Connect the negative battery cable.