Automatic Transmission Fluid (ATF) Replacement
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Hot transmissions and ATF can cause severe burns. Turn off the engine and wait until the transmission and ATF are cool before replacing the ATF.
- Remove the dipstick.
- Remove the drain plug and washer.
- Drain the ATF into a container.
- Install a new washer and the drain plug.
Tightening torque
- 18-22 N.m {1.8-2.3 kgf.m, 14-16 in.lbf}
- Add the specified amount and type of ATF through the oil filler tube.
ATF type
- M-III or equivalent (e.g.Dexron°III)
Fill amount (approx.quantity)
- 6.7 L {7.1 US qt, 5.9 Imp qt}
- Install the dipstick.
- Verify that the ATF level is in the HOT 65°C {149°F}
range.
- Add ATF to the specified level if necessary.