LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 514 (Conventional Brake System) >> Brake Pedal Adjustment >> Brake Pedal Height Adjustment

Brake Pedal Height Adjustment

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the brake switch connector.
  2. Loosen locknut B and turn switch A until it does not contact the pedal.
  3. Loosen locknut D and turn rod C to adjust the height.
  4. Tighten the bolt with locknut B so that clearance between the bolt for brake switch A and pedal stopper is within the specification.

    Specification 

    1. 0.1-1.0 mm {0.004-0.039 in} 

    Tightening torque 

    1. 13.8-17.6 N.m {140-180 kgf.cm, 122-156 in.lbf} 
    Fig 1: Identifying Clearance Between Bolt For Brake Switch And Pedal Stopper
    G03638229Courtesy of MAZDA MOTORS CORP.
  5. Connect the brake switch connector.
  6. After adjustment, inspect the pedal play and the brake light operation.
scientia non olet · About LEMON Manuals