LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 498 (Emission System) >> Evaporative Emission (EVAP) System Leak Detection Pump Inspection >> Resistance Inspection

Resistance Inspection

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Perform the following test only when directed.
  1. Disconnect the negative battery cable.
  2. Inspect resistance of the EVAP system leak detection pump.
    • If not as specified, replace the EVAP system leak detection pump.
    • If as specified, carry out the "Circuit Open/Short Inspection".
      • Fig 1: Inspecting Resistance Of EVAP System Leak Detection Pump
      G03637868Courtesy of MAZDA MOTORS CORP.
      Fig 2: Identifying Terminal
      G03637869Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals