Engine Tune-up Preparation
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Warm up the engine to normal operating temperature.
- Shift transmission into Neutral (MT) or P position (AT).
- Turn off all electrical loads.
- Headlight
- Blower
- Rear window defroster
- Verify that the battery is fully charged. (See BATTERY INSPECTION .)
- Wait until the electrical fan stops.
- Connect the SST (WDS or equivalent) to the DLC-2.
- Access RPM PID.
- Short the DLC terminal TEN to body GND using a jumper wire.
- Select "START" to begin.