Door Sash Film Installation

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Remove any grease or dirt from the affixing surface of the door.
Cut away the unused portion along the dotted lines.

Fig 1: Cutting Away Unused Portion
Courtesy of MAZDA MOTORS CORP.
Peel off the backing paper and attach the door sash film onto the door as shown in the figure.
Standard clearance
1. : 0-1.0 mm {0-0.03 in}
2. : 3.0-5.0 mm {0.12-0.19 in}
3. : 3.0 mm {0.19 in} or less
Peel off the transparent protective film on the door sash film.

Fig 2: Peeling Off Transparent Protective Film On Door Sash Film
Courtesy of MAZDA MOTORS CORP.