LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 472 (Air Bag System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures >> Deployment Procedure for Inside of Vehicle >> Pre-tensioner seat belt

Pre-tensioner seat belt

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door lower trim.

    (See REAR DOOR LOWER TRIM REMOVAL/INSTALLATION .)

  2. Remove the pre-tensioner seat belt and connect the SST  (Adapter harness) as shown in the figure. (See FRONT SEAT BELT REMOVAL/INSTALLATION .)
  3. Install the pre-tensioner seat belt.
    Fig 1: Connecting SST (Adapter Harness) To Seat Belt Pretensioner
    G03702899Courtesy of MAZDA MOTORS CORP.
  4. Connect the SST  (Deployment tool) to the SST  (Adapter harness).
  5. Connect the SST  (Deployment tool) to the battery. Connect the power supply red clip to the positive battery terminal, and the black clip to the negative battery terminal.
  6. Verify that the red lamp on the SST  (Deployment tool) is illuminated.
  7. Verify that all persons are standing at least 6 m {20 ft}  away from the vehicle.
    Fig 2: Connecting SSTs (Deployment Tool) To SSTs (Adapter Harness)
    G03702900Courtesy of MAZDA MOTORS CORP.
  8. Press the activation switch on the SST  (Deployment tool) to operate (deploy) the pre-tensioner seat belt.
    Fig 3: Identifying Activation Switch On SST (Deployment Tool)
    G03702901Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals