Adjustment Shim, Side Bearing Outer Race Disassembly Note

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Remove the adjustment shim using a flathead screwdriver.

Fig 1: Removing Adjustment Shim
Courtesy of MAZDA MOTORS CORP.
Put left and right identification marks on the removed adjustment shims and side bearing outer races.

Fig 2: Putting Left And Right Identification Marks On Adjustment Shims And Side Bearing Outer Races
Courtesy of MAZDA MOTORS CORP.