LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 452 (Drive Shaft) >> Rear Drive Shaft Disassembly/Assembly >> Snap Ring, Tripod Joint Disassembly Note

Snap Ring, Tripod Joint Disassembly Note

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place an alignment mark on the shaft and tripod joint.
  2. Remove the snap ring using a snap ring plier.
  3. Remove the tripod joint from the shaft.
    CAUTION:
    • To prevent damage to the component, do not use a hammer when removing it.
    Fig 1: Placing Alignment Mark On Shaft And Tripod Joint
    G03702269Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals