Charcoal Canister Inspection

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Remove the charcoal canister. (See EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM REMOVAL/INSTALLATION .)
Plug ports A and C, then blow air into port B.
CAUTION:
- Do not apply the pressure more than 20 kPa {0.2 kgf/cm² , 2.8 psi} to the charcoal canister. Doing so will damage the charcoal canister.
Verify that there is no air leakage from the case.
- If not as specified, replace the charcoal canister.
Fig 1: Identifying Charcoal Canister
Courtesy of MAZDA MOTORS CORP.